/Products/replacement of fine aggregate with marble dust pdf

replacement of fine aggregate with marble dust pdf

Partial Replacement of Fine Aggregates by Marble Powder in

used as the partial replacement of fine aggregates in concrete pavements. Marble powder is present abundantly and degrades the land on which it is laid. This paper reports the evaluation on the properties of marble dust. The marble dust used as fine aggregate in replacement of natural sand, as the sand is expensive because of the excessive cost of

Partial Replacement of Fine Aggregates with Quarry Dust

alternative to fine aggregate in concrete. In the present investigation workability and strength of concrete was evaluated by replacement of natural sand by Quarry dust

Influence of Marble Dust as Partial Replacement of Cement

D. Marble Dust It is waste dust obtained in marble industries and marble stone quarry. Physical properties like specific gravity 2.7 and Fineness 10%,pale white fine powdered appearance. Chemical properties obtained of marble dust are shown below. Table 5 Chemical properties of Marble Dust Test conducted Test Results Silica Si0 2 (% by mass) 9.04

EXPERIMENTAL INVESTIGATION OF PARTIAL REPLACEMENT

Shirule et al: studied the ―Partial Replacement of cement with Marble Dust Powder‖. It can be concluded that for M20 grade concrete The It can be concluded that for M20 grade concrete The Compressive strength of Cubes are increased with addition of waste marble powder up to 10% replace by weight of cement and further any

Effects of Partial Replacement of Cement with Marble Dust

Effects of Partial Replacement of Cement with Marble Dust Powder on Properties of Concrete Sonu Pal Amit Singh Concrete is a heterogeneous mix of cement, aggregate (coarse and fine aggregate) and water. Aggregate can not only limit the strength of concrete but also affect the durability and performance of concrete. The

Utilization of Demolish Brick and Marble Waste in Concrete

the suitability of using brick ballast and marble waste in concrete. Three replacement levels 10%, 20% and 30%, were Fine Aggregate: then was washed to remove the dust. The specific gravity and water absorption are 2.7 and 0.99 and fineness modulus is 2.5.

(PDF) REPLACEMENT OF FINE AGGREGATE WITH SAWDUST

Apr 01, 2017 In Group 3, wood waste aggregate has been used as a partial replacement of 10%, 15%, 20%, 25% and 30% by volume of coarse aggregate. The specimens were conditioned for 28-days at 80±5% Relative

(PDF) A DETAILED STUDY ON PARTIAL REPLACEMENT OF FINE

The waste bricks as obtained from garbage of a broken building were collected and pulverized to get the particle passing 4.75 mm sieve and retained on 0.075 mm sieve to get the grading of fine aggregate. 5, 10, 15, and 20% brick powder is used as replacement of fine aggregate in the experiments.The aim of the experiment was to assess the

(PDF) Utilization of Solid Waste in Cement Brick: A Review

Coarse and fine aggregates are replace with recycled marble and granite waste at 0%, 10%, 20%, 30%, 40%. The compressive strength and water absorption are carried out for brick. From the test, 10% replacement of coarse and fine aggregate with marble and granite waste gives compressive strength 43.48 MPa and water absorption is less than 8%. [15]

Project on Partial Replacement of Cement with Marble Powder

Weight of fine aggregate = 1.372 x 3773.85 = 5.177 kg From the above study, it is concluded that the marble dust can be used as a replacement material for cement ; and 10% replacement of marble dust gives an excellent result in strength aspect and quality aspect and it is better than the control concrete. The results showed that the

PARTIAL REPLACEMENT OF FINE AGGREGATE BY WASTE

possibilities of using Marble dust as a replacement to fine aggregate. Present investigation aimed at to study, 0%, 10%, 20% and 30% of traditional fine aggregate was replaced with Marble dust. Compressive strengths and split tensile strength were found after 14 days and 28 days of curing. By adding or by substitution for the cementations and

Partial Replacement of Fine Aggregates by Marble Powder

used as the partial replacement of fine aggregates in concrete pavements. Marble powder is present abundantly and degrades the land on which it is laid. This paper reports the evaluation on the properties of marble dust. The marble dust used as fine aggregate in replacement of natural sand, as the sand is expensive because of the excessive cost of

Impact of Marble Waste with Partial Replacement of Fine

According to IS 10262-2009, control specimens were structured with 0% squander marble powder to accomplish M25 evaluation of concrete as appeared in table I. To contemplate the impact and properties of cement with various proportions of substitution (25%, half, 75% and 100%) of normal sand with fine marble dust as fine totals and

Review on the feasibility of Marble Dust as Replacement of

Earlier analysis conjointly indicate that the consequences of blending marble dust on the different properties of cement like setting times, consistency as well as soundness stay at intervals the appropriate ranges of various standards. It's been used as a replacement of fine aggregates as well as course aggregate in several literature

Strength Characteristics of Concrete Produced by Replacing

aggregates and the high cost of construction materials has necessitated the quest for alternative materials. This study investigates the combined effect of using marble dust (MD) and iron filings (IF) as a partial replacement for fine aggregates (sand) in concrete production. Concrete cubes measuring 150 X 150 X 150 mm3, were

EXPERIMENTAL INVESTIGATION OF PARTIAL

Shirule et al: studied the ―Partial Replacement of cement with Marble Dust Powder‖. It can be concluded that for M20 grade concrete The It can be concluded that for M20 grade concrete The Compressive strength of Cubes are increased with addition of waste marble powder up to 10% replace by weight of cement and further any

(PDF) IJERT-Use of Waste Marble Powder as Partial

Download Free PDF. Download Free PDF. IJERT-Use of Waste Marble Powder as Partial Replacement in Cement Sand Mix. In this experimental study, fine marble powder dust was collected from the nearby source for the investigation. (IOSR-JMCE) maximum when replace with fine aggregate up to (9) IS:8112-1989, Indian standard of ordinary

© 2020 JETIR May 2020, Volume 7, Issue 5 EXPERIMENTAL

fine/natural aggregate substituted by GP waste. The experimental results were shown that substitution of granite and marble powder waste up to 15 % of any formulation of concrete is favorable form the normal concrete making and it is concluded that granite powder waste can be used as alternative aggregates for normal concrete.

Replacement of Fine Aggregates by Mixture of Ceramic

partial and full replacement of fine aggregate by mixture of ceramic and marble powder in equal proportions. The reason for using ceramic and marble as fine aggregates is that both of them are waste materials in the form of broken insulators and marble chippings respectively, with marble powder also possessing cementitious properties.

Effect of Partial Replacement of Cement by Fly Ash and

[1] Bahar Demirel “The Effect of the using waste marble dust as fine sand on the mechanical properties of the concrete ”International journal of physical Science Vol. 5(9),Pp. 1372-1380, 18 August,2010 Quarry dust and Marble sludge powder As Fine Aggregate ” Arpon Journal of

ISSN 2348 7968 Replacement Of Cement By Marble Dust

proportion (cement: fine aggregate: coarse aggregate) is 1:1.5: 3 by volume and a water cement ratio of 0.50. 5. Experimental Methodology The evaluation of Ceramic Waste Powder and Marble Dust Powder for use as a replacement of cement material begins with the concrete testing. The study is conducted to

Experimental Study on concrete with Partial Replacement of

Marble Dust (a) Marble dust is waste materials which are produced during the process of cutting of marble. (b) In each year approx 175 million tones of marble dust are produced as waste materials. METHODOLOGY Step 1 Problem identification Step 2 Selection of Material: Cement, Fly ash, Marble Dust, Fine aggregates, Coarse aggregate.

[PDF] Partial Replacement of Cement with Marble Dust

experimental study on partial replacement of cement with marble powder and fine aggregate with quarry dust Gudavalli Sai Abhilash,Parvez Khan,G. Manikantasai 2017

An Investigation on Utilization of Marble Dust and Rice

fine aggregate used in the research is verified as per IS 2386-1963 Indian standards. The sand used is sieved with 4.75mm to avoid any gravels. Table 1: Physical properties of fine aggregate Description Fine aggregate Specific gravity 2.5 Water absorption 1.64 Finess modulus 4.25 D 60 0.63 D 10 0.375 Co efficient of uniformity 2.5

Effects of Partial Replacement of Cement with Marble Dust

Effects of Partial Replacement of Cement with Marble Dust Powder on Properties of Concrete Sonu Pal Amit Singh Tests of Fine Aggregate S. No. Test Fine Aggregate 1 Zone II 2 Moisture content 0.25% 3 Specific gravity 2.64 4 Bulk density 1.61 gm/cc 5 Fineness Modulus 2.42

Review on the feasibility of Marble Dust as Replacement of

Earlier analysis conjointly indicate that the consequences of blending marble dust on the different properties of cement like setting times, consistency as well as soundness stay at intervals the appropriate ranges of various standards. It's been used as a replacement of fine aggregates as well as course aggregate in several literature

ISSN 2348 7968 Replacement Of Cement By Marble Dust

proportion (cement: fine aggregate: coarse aggregate) is 1:1.5: 3 by volume and a water cement ratio of 0.50. 5. Experimental Methodology The evaluation of Ceramic Waste Powder and Marble Dust Powder for use as a replacement of cement material begins with the concrete testing. The study is conducted to

[PDF] Partial Replacement of Cement with Marble Dust

experimental study on partial replacement of cement with marble powder and fine aggregate with quarry dust Gudavalli Sai Abhilash,Parvez Khan,G. Manikantasai 2017

An Investigation on Utilization of Marble Dust and Rice

fine aggregate used in the research is verified as per IS 2386-1963 Indian standards. The sand used is sieved with 4.75mm to avoid any gravels. Table 1: Physical properties of fine aggregate Description Fine aggregate Specific gravity 2.5 Water absorption 1.64 Finess modulus 4.25 D 60 0.63 D 10 0.375 Co efficient of uniformity 2.5

© 2020 JETIR May 2020, Volume 7, Issue 5 EXPERIMENTAL

fine/natural aggregate substituted by GP waste. The experimental results were shown that substitution of granite and marble powder waste up to 15 % of any formulation of concrete is favorable form the normal concrete making and it is concluded that granite powder waste can be used as alternative aggregates for normal concrete.

Replacement of Fine Aggregates by Mixture of Ceramic

partial and full replacement of fine aggregate by mixture of ceramic and marble powder in equal proportions. The reason for using ceramic and marble as fine aggregates is that both of them are waste materials in the form of broken insulators and marble chippings respectively, with marble powder also possessing cementitious properties.

EXPERIMENTAL STUDY ON PARTIAL REPLACEMENT OF

The specific gravity of fine aggregate was 2.60. Locally available river sand conforming to Grading zone I of IS: 383 –1970.Clean and dry river sand available locally will be used. Sand passing through IS 4.75mm Sieve will be used for casting all the specimens. 3.3 Coarse Aggregate:

Project On Marble Sludge Powder As Fine Aggregate In Pdf

An Experimental Investigation Of Partial Replacement Of . Marble sludge powder In natural stone processing plants large amounts of marble dust are generated with an important impact on environment and humans This project describes the feasibility of using the marble sludge dust in concrete production as partial replacement of fine aggregate In INDIA the marble

Characteristics of granite dust concrete with M−sand as

Jan 01, 2020 The current investigation is preceded with fractional replacement of cement with granite dust at different proportions of 0%, 5%, 10%, 15% and 20% by weight of the cement for M30 grade of concrete and 50% replacement of natural sand with the manufactured sand as a fine aggregate.

Experimental Study on Use of Waste Marble Dust in Concrete

Waste marble dust is one such material which can be used to replace sand as fine aggregate. The present study is aimed at utilizing Waste marble powder as fine aggregate in concrete, replacing natural sand. Marble is one of the most important materials used in buildings since ancient times,

EXPERIMENTAL STUDY ON PARTIAL REPLACEMENT OF CEMENT

Corpus ID: 212600892. EXPERIMENTAL STUDY ON PARTIAL REPLACEMENT OF CEMENT WITH MARBLE POWDER AND FINE AGGREGATE WITH QUARRY DUST @inproceedings{Abhilash2017EXPERIMENTALSO, title={EXPERIMENTAL STUDY ON PARTIAL REPLACEMENT OF CEMENT WITH MARBLE POWDER AND FINE AGGREGATE WITH QUARRY DUST

“Green Concrete: Using Industrial Waste of Marble Powder

rock dust and marble sludge powder may be used as a replacement material for fine aggregate. The replacement of fine aggregate with 50% marble sludge powder and 50% Quarry rock dust (Green concrete) gives an excellent result in strength aspect and quality aspect. Increase the marble sludge

IJISRT21MAR007.pdf Volume 6 Issue 3 March \u2013 2021

This study investigates the combined effect of using marble dust (MD) and iron filings (IF) as a partial replacement for fine aggregates (sand) in concrete production. Concrete cubes measuring 150 X 150 X 150 mm 3, were cast, using a mix ratio of 1:2:4 and a water/cement ratio of 0.5.